Unicorn Applique

Description

CrazyPC Window Appliqu�s are used to give the appearance of a sand blasted or etched window. Our appliqu�s are made from quality translucent vinyl and are easily applied within a matter of minutes.

Appliqu� Dimensions

• Unicorn - 7" width x 6.5" height

Instructions

PLEASE READ ALL INSTRUCTIONS BEFORE INSTALLING.

1. Clean window completely using an acrylic-friendly cleanser.  Most window cleaners and products containing ammonia are NOT acrylic-friendly!  CrazyPC recommends using soap and water for this process.
2. Dry the window.  Make sure that there is no soap left on it.
3. Spray a fine mist of water over the surface of the window.
4. Remove the opaque backing from the translucent backing.  Make sure that the sticker stays on the translucent backing.
5. Carefully apply the sticker to the acrylic pane.
6. Remove translucent backing from the sticker.
7. Using a squeegee (flat edge of credit card), remove any air bubbles, working out from the center. Any trapped bubbles can be left for step 9.
8. Wait 24 hours.  You will notice that the etched effect improves as the adhesive dries.
9. After the 24 hours has passed, look for air bubbles.  Using a needle, poke a hole in the middle of each air bubble.  Squeeze the air bubble out through the hole.

If you wish to remove your appliqu�, carefully strip it off and wash the window as necessary.

Crazypc.com is not responsible for damage to equipment caused by incorrectly executed installations.

* Counter-Strike is created by the Counter-Strike Team.